How to Recover Deleted Quickbooks Files
@salena_gomes wrote: You can keep your version up-to-date without much hassle.Why have you wait for three days or even one day to fix corruption in your QuickBooks files? A good news for all...
View ArticleBootable SD? Is it possible?
@apxii wrote: Hi! Is it possible to have a BPI W2 booting from SD Card? I’ve seen bootloader on SPI flash is looking for specially crafted SD if it is inserted at boot time. Is there a documentation...
View ArticleBPI-R2 USB support
@xbgmsharp wrote: Hello, I wish to use a USB device with Kernel 4.9 CONFIG_SCSI=y CONFIG_USB=y CONFIG_USB_STORAGE=y CONFIG_USB_XHCI_MTK=y CONFIG_USB_NET_DRIVERS=y On boot i can see # dmesg | grep usb...
View Article[ubuntu 16.04 mate] how to set mac adress of wlan0?
@nicoo wrote: hi, I just noticed that wlan0 got random mac adress after a reboot, I tried to set it with: ip link set wlan0 address XX:XX:XX:XX:XX:XX but I got: RTNETLINK answers: Operation not...
View ArticleLatest BPI-R2 rev 1.2 hardware SD/EMMC switch purpose?
@codeminutia.com wrote: Can anyone tell me what the purpose of that switch that sits by the SD card, where there used to be the battery connector on the old boards? I tried switching between SD and...
View ArticleRecover EDB PST Software
@MichaelKemp wrote: If you want to repair all corrupt Exchange EDB file,so quickly download this superb Exchange EDB to PST Converter that can repair and recover all over EDB file data from MS...
View ArticleWhy doesn't the BPI-R2 board not even power if no SD card?
@codeminutia.com wrote: Does anyone know why does the BPI-R2 board not even power on if there is no SD card inserted in the SD slot. I followed the procedure below to get the system to boot from EMMC:...
View ArticleSQUASHFS error: Unable to read fragment cache entry
@codeminutia.com wrote: Anyone else seeing lots of squashfs errors in dmesg? I see lots of these, both when booting from SD or EMMC so I don’t think it’s media related. [ 33.237519] SQUASHFS error: xz...
View ArticleClik here to view.
How to make a SD card with bootloader
@BOE wrote: introduction there are two ways to boot w2, controlled by SW4 boot from emmc. boot from SPI + SD card. After power on, there are 3 steps must be done before loading kernel,(Normally they...
View ArticleWLAN connected, but no internet access
@JesseVoss wrote: Hello, I installed a clean Raspian from the newest NOOBS 1.9.1 setup on my Raspberry Pi B+. On boot the WLAN-Dongle is connected. I used the GUI to connect to my WPA2 protected...
View ArticleProblem with wifi - Banana Pi R1 Core 107
@JesseVoss wrote: Hey, I’ve had this problem also with Core 105 and Core 106:When I’m connected to the blue wifi interface after some time I’m not able to connect to the internet or ping any device on...
View ArticleWatchdog detection after watchdog reset
@JesseVoss wrote: Hi, I have non Linux question about the A33. Maybe someone could help me:I working on an A33 and would like to detect if the watchdog has rest my board. Is there a register, that...
View ArticleTroubleshooting Windows Updates issues in Windows 10 IOT Core
@JesseVoss wrote: Hi, I’m having issues with my RPI3 running Windows 10 IOT Core, where it’s not able to successfully install all the needed updates. I was going to check the logs, but...
View ArticleBanana pi BPI-W2 40 PIN GPIO function test
@sinovoip wrote: Banana pi BPI-W2 40 PIN GPIO function test Posts: 1 Participants: 1 Read full topic
View ArticleBanana Pi W2 NAS Server
@Anastasis_Pastras wrote: I wanted to make a NAS Server and I came across the banana pi w2. I saw all the storage compatability that it had. But i dont know how to make oone. Can someone help me....
View ArticleBPI W2 sources for Linux, etc
@apxii wrote: Hi! Is it possible to have the sources for Linux kernel, u-boot, LK, OP-TEE, ATF, etc… for BPI W2? Posts: 2 Participants: 2 Read full topic
View ArticleKann ich RaspberryOriginal-Images verwenden?
@Karl wrote: Hallo, ich habe einen MPI Ultra bestellt, (er ist noch nicht da) Kann ich das Original-Image von Raspberry - 2018-04-18-raspbian-stretch - verwenden, oder nur das Image von Banana Pi?? Wo...
View ArticleClik here to view.
Banana pi BPI:bit batch production complete, official global release
@sinovoip wrote: Banana pi BPI:bit batch production complete, official global release. bpi bit webduino 1.png700x372 87.8 KB BPI:bit full support Webduino function, for STEAM education and IoT...
View ArticleClik here to view.
Banana Pi BPI-M2P New Image Release Raspbian jessie 8.0 2018-5-22
@Jackzeng wrote: Banana Pi BPI-M2P New Image Release: Raspbian jessie 8.0 V1.1 M2P_Raspbian.jpg692x583 190 KB 1.About this release This release is for banana pi M2P board which is based on Allwinner...
View Article[Error while booting] sunxi_ss_alg_register()681 - crypto_register_ahash(md5)...
@BananasHavePotassium wrote: Hi my BananaPi M2 Ultra with Ubuntu Mate installed stopped working after power off It stucks on: sunxi_ss_alg_register()681 - crypto_register_ahash(md5) failed! return -22...
View Article
